Legal Removal Request

Post: [b]I will try to measure the bearing temperature and also winding temperature for AC motor.[/b] [b]Those temperature will be measured with embedded PT100 (100Ohm at 0[/b][b]?[/b][b],119.4Ohm at +50[/b][b]?[/b][b], 157.31Ohm at +150[/b][b]?[/b][b], Liner)[/b] [b]2 x PT100 for bearing temperature[/b] [b]3 x PT100 for winding temperature.[/b] Total 5 channels and show the temperature every 60 seconds at console display. [b]I have already bought Raspberry Pi3 model B and RASPBIAN has installed in this June.[/b] [b]I found ADC Pi Plus with some mounting kit for temperature measurement and it will arrive soon.[/b] [b] However, I am Mechanical engineer and no back ground for PC, IT, electronics.[/b] [b]I think need the preparation before temperature measurement. I do not know below is correct procedure or not but just listed.[/b] I2C address section. I have no idea. The measured data is good accuracy as much as possible. Where is the location of jumper pin ? From AB Electronics Python Library, Source code for ADC Pi Plus will be down load. Which source code must be down load ? In Knowledge base, there are several application software as demo. To measure the temperature with PT100, which demo can be used ? Wire connection from PT100 to ADC Pi Plus. PT100 with 2 wires. One connect to 0V on ADC Pi Plus, another one connect to 1 (1ch) ? Is voltage divider necessary ? Where additional resistor will be mounted for 5 x channels ? To measure the temperature 0? to +150? with PT100?What is the value of resistance and how many resistance will be added ? I appreciate your help and response. Hideaki Hashikura Tokyo/Japan