ADC Read Problem
The ADC Pi is an Analogue to Digital converter for the Raspberry Pi
09/02/2021
Posted by:
Andr22
When running the ADC read code, there is no output to the terminal. Given the code stops if the SPI bus fails to open, I believe this to be the issue. I have enabled SPI in using the device tree paramters of the Pi as follows:
dtparam=i2c=on,i2s=on,spi=on
This doesn't have any effect. What needs to be done to correctly read the voltage and output it?
dtparam=i2c=on,i2s=on,spi=on
This doesn't have any effect. What needs to be done to correctly read the voltage and output it?
09/02/2021
Posted by:
Andr22
Update: manually enabled the SPI interface using the sudo raspi-config command
Note: documents in Portable Document Format (PDF) require Adobe Acrobat Reader 5.0 or higher to view.
Download Adobe Acrobat Reader or other PDF reading software for your computer or mobile device.