1 Wire Pi Support (Page 3)
The AB Electronics UK Support Forum is where you can post questions and answers for the 1 Wire Pi Zero and 1 Wire Pi Plus Raspberry Pi expansion boards. Visit our Knowledge Base for 1 Wire Pi tutorials and articles.
The 1 Wire Pi Plus is a communication board supporting the 1-Wire protocol designed for the Raspberry Pi and other compatible single-board computers.
Using OWFS or the W1 Linux Subsystem, you can access your 1-Wire devices as files within the Linux filesystem.
How to enable parasitic power pull-up?
Posted in 1 Wire Pi, last reply 24/12/2018
Replies: 8
RJ12 Socket
Posted in 1 Wire Pi, last reply 10/06/2018
Replies: 2
Pull Up resistor
Posted in 1 Wire Pi, last reply 01/04/2018
Replies: 1
1 Wire & my Devices
Posted in 1 Wire Pi, last reply 03/02/2018
Replies: 5
Power-up settings
Posted in 1 Wire Pi, last reply 12/11/2017
Replies: 2
1Wire device not showing up
Posted in 1 Wire Pi, last reply 27/10/2017
Replies: 5
Make sensors show up in /sys/bus/w1/devices ?
Posted in 1 Wire Pi, last reply 13/10/2017
Replies: 1
Getting a different sensor ID with 1 wire plus
Posted in 1 Wire Pi, last reply 09/10/2017
Replies: 5
No i2c detected
Posted in 1 Wire Pi, last reply 17/08/2017
Replies: 2
1WPi+ does not see any sensor
Posted in 1 Wire Pi, last reply 01/08/2017
Replies: 2
w1_master_driver w1_bus_master1: Family 0 for 00.700000000000.f8 is not registered.
Posted in 1 Wire Pi, last reply 30/01/2017
Replies: 3
no detect any 1wire device
Posted in 1 Wire Pi, last reply 13/01/2017
Replies: 2